Ricoh AP1400/AP2000 - Manual (Page 111)

Type 2 Printer: Loading Paper and Other Media
91
9
❒ Make sure that the setting of the
paper size dial matches the paper
size and feed direction in the tray.
Otherwise, the printer might be
damaged, or printing problems
might occur.
Reference
For more information on the size
and feed direction of paper that
can be loaded in the tray, see P.65
“Paper and Other Media Supported
by Your Printer”.
A
Pull the paper tray out until it
stops. After that, lift it slightly,
then pull it out of the printer.
Note
❒ Do not touch the three white
pins on the right front side of
the printer.
B
Adjust the paper size dial to
match the size and feed direction
of paper in the paper tray.
C
Adjust the rear and left side
guides to the paper size you want
to load.
D
Load paper into the paper tray
with the print side up.
Important
❒ Make sure the top of the stack is
not higher than the limit mark
inside the tray.
❒ Make sure the paper fits under
the rear guide.
E
While lifting the front side of the
tray, place the tray into the print-
TS4Y150E
A4
TS4Y160E
TS4Y170E
TS4Y180E