Ricoh AP1400/AP2000 - Manual (Page 85)

65
9. Paper and Other Media
Paper and Other Media Supported by
Your Printer
Paper Types and Sizes
This section provides the type, size, feed direction, and maximum capacity of
paper that can be loaded into each paper tray in this printer.
Important
❒ If you use damp or curled paper, a misfeed might occur. In such a case, try
turning over the paper stack in the paper tray. If there is no improvement,
change to paper with less curl.
Note
❒ The meaning of the symbols describing paper can be seen in the table below.
❒ It is recommended that you load paper having the size and direction you fre-
quently use in the tray selected with the “Tray Priority”. For details on Tray
Priority, see P.128 “Job Control Parameters”.
❒ When loading paper having the same size in more than one tray, it is recom-
mended that you load paper in the same direction.
Reference
For details on loading each type of paper, see P.79 “Type 1 Printer: Loading Pa-
per and Other Media”, and P.88 “Type 2 Printer: Loading Paper and Other Media”.
Type 1 Printer
Note
❒ Please refer to the inside of the front cover of this manual to confirm which
printer (Type 1 Printer or Type 2 Printer) you have.
Important
❒ Be sure to set the paper size dial to match the actual paper size loaded in the
tray. When the actual paper size is not shown on the dial, set the dial to “
p”
and specify the paper size using the operation panel.
In this manual On the panel display Meaning
K
mn short-edge feed direction
L
op long-edge feed direction