Ricoh AP1400/AP2000 - Manual (Page 95)

Paper and Other Media Supported by Your Printer
75
9
❖ ❖ ❖ ❖ OHP transparencies
• Load only one OHP transparency at a time onto the bypass tray.
• When loading OHP transparencies onto the bypass tray, set the printer to
the Thick Paper mode using the operation panel.
⇒
P.125 “Making Printer
Settings with the Operation Panel”
• Be careful not to touch the print side of the OHP transparencies. Other-
wise, the print side gets dirty or damaged, and results in poor print quality.
• When printing on an OHP transparency that has a print side, load it face
down onto the bypass tray.
❖ ❖ ❖ ❖ Translucent paper
• Load only one translucent paper at a time onto the bypass tray.
• When printing on translucent paper that has a print side, load it face down
onto the bypass tray.
❖ ❖ ❖ ❖ Adhesive labels
• Load only one adhesive label at a time onto the bypass tray.
• Use adhesive labels in which the whole side can be printed on.
• Avoid using adhesive labels having exposed glue.
• If the print side is coated, the print quality might be reduced, as the toner
might not fuse well.
❖ ❖ ❖ ❖ Envelopes
• When printing on envelopes, use the bypass tray or the optional envelope
feeder.
• Even when the optional envelope feeder is not installed, you can specify
the sizes for the envelopes for tray 2 using the operation panel. However,
the envelopes cannot be loaded into tray 2 without the envelope feeder.
To use the envelope feeder, the installation of the optional paper unit is re-
quired.
⇒
P.16 “Type 1 Printer: Installing the Envelope Feeder Type 2000”, P.21
“Type 2 Printer: Installing the Envelope Feeder Type 1400”.
• Specification of envelopes are as follows:
• For the Type 1 printer, you can load up to 10 envelopes (72 – 90 g/m 2 , 19 –
24 lb) onto the bypass tray at a time, without forcibly pressing them. How-
ever, make sure that the envelopes are not damp, and that the top of the
stack is not higher than the limit mark on the side guide.
⇒
P.84 “Type 1
printer: loading envelopes onto the bypass tray”
Metric version Inch version
Weight 72 – 90 g/m 2 19 – 24 lb
Recommended weight
and size 72 g/m 2 , 114
×
162 mm
(C6 Env)
24 lb, 3 7 /
8
"
×
7 1 /
2
"
(Monarch)