Ricoh AP1400/AP2000 - Manual (Page 131)

Removing Misfed Paper
111
10
B
Slide the paper tray back into the
printer until it stops.
C
Open the front cover, and then
close it to reset the misfeed condi-
tion.
Important
❒ If paper is fed from the bypass
tray, be sure to remove all the
paper from the bypass tray and
close it before opening the front
cover.
When “Remove Misfeed: Open
Front Cover” Appears
Important
❒ Be sure to release the pressure re-
lease levers before removing mis-
fed paper. Otherwise, the printer
might be damaged.
❒ If you can see the misfed paper
when opening the front cover, re-
move the misfed paper from the
front side. If you remove the mis-
fed paper from the output tray, the
unfused toner might make the in-
side of the printer dirty.
A
Open the front cover by pulling
the front cover release buttons.
B
Push the blue pressure release le-
vers marked with (A).
R WARNING:
If you cannot find the misfed
paper in the output tray
A Pull out the misfed paper by
holding both sides of the pa-
per.
TS3Y100E
TS3Y210E
• Be careful not to touch the
fusing unit as it could be very
hot.
TS3H060E
TS3Y230E