Ricoh AP1400/AP2000 - Manual (Page 36)

Installing Options
16
2
Type 1 Printer: Installing the
Envelope Feeder Type 2000
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
Important
❒ This unit is a tray that slides into
the optional paper feed unit. With-
out the optional paper feed unit,
this envelope feeder cannot be
used.
❒ The Type 1 Printer can have two
optional paper feed units installed
at a time. However, the envelope
feeder should be used in the top-
most optional paper feed unit (tray
2). It can not be used in the bottom-
most paper feed unit (tray 3).
❒ Do not slide more than one paper
tray out at a time. Having more
than one paper tray filled with pa-
per in a fully extended position
could cause the machine to tilt to-
ward.
A
Check the content in the box for
the following items.
• Envelope feeder
• Installation Guide
B
Pull out the 2nd paper tray (tray 2)
of the optional paper feed unit
until it stops. After that, lift it
slightly, then pull it out.
Important
❒ The envelope feeder should be
used in the top-most optional
paper feed unit (tray 2).
Note
❒ Keep the paper tray with paper
in a cool and dry place.
C
While lifting the front side of the
envelope feeder, place the feeder
into the printer. Then slide it into
the printer until it stops.
Note
❒ When loading envelopes, see
P.84 “Type 1 Printer: Loading En-
velopes”.
Type 1 Printer: Installing the
Network Interface Board Type
2000
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
TS3Y150E
TS3Y290E