Ricoh AP1400/AP2000 - Manual (Page 211)

Replacing Parts
12
2
Printing the Test Page
You can confirm that the printer
works properly by printing a test
page (configuration page).
A
Insert the plug of the power cord
securely into the wall socket.
Turn the printer's power switch
on.
B
Load paper with the print side up
into the paper tray. Slide the pa-
per tray into the printer until it
stops.
Note
❒ If you have an optional paper
feed unit, repeat the above pro-
cedure for the tray.
C
Move the printer to the place
where it was installed. If you
have the optional paper feed unit,
place the printer securely on the
unit.
D
Print the test page following the
procedure below:
A Press {{{{
Menu
}}}}.
The following message appears
on the panel display.
Main Menu: j
Job Control l
B Press {{{{U U U U}}}}{{{{T T T T}}}} until the follow-
ing message appears on the
panel display.
Main Menu: j
List Print l
C Press {{{{
Enter
}}}}.
The following message appears
on the panel display.
List Print: j
1.Config. Page l
D Press {{{{
Enter
}}}}.
The following message appears
on the panel display.
Config. Page
Press Enter Key
E Press {{{{
Enter
}}}} .
In a short time, the test printing
will start.
E
If you can complete the test print-
ing completely, turn off the print-
er's power switch.
Note
❒ If you cannot complete the test
printing completely, confirm
that all of the parts are installed
correctly referring to the men-
tioned procedures.
F
Attach the interface cable to the
interface connector of your print-
er. Turn on the printer's power
switch.
TS4M250E