The following message appears on the panel display, Graphic, K press – Ricoh AP1400/AP2000 User Manual

Page 47: L press, O press, P press, S press, T turn the printer's power switch off and on

Advertising
background image

Setting Up the IP Parameters

27

3

register the IP address you speci-
fied.

The following message appears on
the panel display.

Network Setup: j

1.IP Address l

K

Press

{T}{U} until the following

message appears.

Network Setup: j

2.Subnet Mask l

L

Press

{

Enter

}.

The current subnet mask appears
on the panel display.

Subnet Mask:jld#

255.000.000.000

M

Specify the subnet mask using
the same procedure for specifying
the IP address.

N

Check if the pointer (k) is at the
rightmost digit, press

{

Enter

} to

register the subnet mask you
specified.
The following message appears on
the panel display.

Network Setup: j

2.Subnet Mask l

O

Press

{T}{U} until the following

message appears.

Network Setup: j

3.Gateway l

P

Press

{

Enter

}.

The current gateway address ap-
pears on the panel display.

Gateway jld#

000.000.000.000

Q

Specify the gateway address us-
ing the same procedure for speci-
fying the IP address.

R

Check if the pointer (k) is at the
rightmost digit, press

{

Enter

} to

register the gateway address you
specified.
The following message appears on
the panel display.

Network Setup: j

3 .Gateway l

S

Press

{

On Line

}.

The panel display returns to the
ready condition as follows:

Ready

T

Turn the printer's power switch
off and on.

Advertising