Ricoh AP1400/AP2000 - Manual (Page 304)

NetWare ® Configuration
8
2
A
Double-click on the target NIB.
The first “Print Server Settings” screen appears.
Most of the fields will be configured automatically.
Fill in the following fields with the appropriate information.
❖ ❖ ❖ ❖ Print Server Name
The name that the NIB uses to log into NetWare.
❖ ❖ ❖ ❖ Print Queue Scan Rate
The number of seconds the NIB waits before polling print queues for a new
print job.
❖ ❖ ❖ ❖ Ethernet Frame Type
Sets the default frame type that is used by the NetWare protocol stack.
❖ ❖ ❖ ❖ Print Server Password
Asterisks in this field indicate that a password is needed to log into Net-
Ware and the Network Interface Board.
❖ ❖ ❖ ❖ Change Password
Clicking on this button brings up a dialog box allowing you to set or
change the password.
B
Click on [Next] to continue.
The second “Print Server Settings” screen appears.
Again, most of the fields will be configured automatically.
Fill in the following fields with the appropriate information.
❖ ❖ ❖ ❖ Enable NDS Mode
Indicates whether or not the NIB supports Directory Services.
❖ ❖ ❖ ❖ Preferred NDS Context
The NDS directory context which the NIB uses to login to the network.
❖ ❖ ❖ ❖ Preferred NDS Tree
The NDS tree which the NIB uses to login to the network.
❖ ❖ ❖ ❖ Enable Bindery Mode
Determines whether the NIB services the network in Bindery mode.
Note
❒ If this field is not enabled, then the Primary Server field will not be en-
abled.
❖ ❖ ❖ ❖ Primary File Server
Specifies the file server that the NIB uses as the primary file server.