Ricoh AP1400/AP2000 - Manual (Page 40)

Installing Options
20
2
Type 2 Printer: Installing Options
Type 2 Printer: Installing the
Paper Feed Unit Type 1400
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
Important
❒ Do not slide more than one paper
tray out at a time. Having more
than one paper tray filled with pa-
per in a fully extended position
could cause the machine to tilt for-
ward.
❒ To make the printer recognize the
installed option, you should set up
the option with the printer driver.
A
Check the contents of the box for
the following items.
• Paper feed unit (including a
paper tray)
• Installation Guide
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
• The interface cable is un-
plugged from the printer.
• The bypass tray and front cov-
er are closed.
C
At the front of the paper feed unit,
tape on the left and right sides is
used to hold the tray in place. Re-
move both pieces of tape.
D
There are four pins on the top of
the paper feed unit that point
straight up. On the bottom of the
printer are four holes. Align the
holes over the pins and lower the
printer gently onto the paper feed
unit.
R CAUTION:
E
Pull the paper tray out until it
stops. After then, lift it slightly,
• When lifting the printer, use the
inset grips on both sides.
TS4P121E
TS4K010E