Ricoh AP1400/AP2000 - Manual (Page 275)

Chapter 7 - 18
2. Type 1 again and press the ENTER key. The IP Address submenu will appear:
The Configuration Utility
Unit Serial no. 991398 v2.18
IP Parameters
1. IP Address
2. Subnet Mask
3. Default Gateway
4. Base Port Number
Please Enter Selection (? for Help) :
3. Enter a new IP Address and press the ENTER key. Repeat the previous steps to change
Subnet Mask and Default Gateways.
4. Enter 4 to change the base port number.
Note: The base port number is one less than the actual TCP/IP port number used by
the printer. For example, to set the port number to 9100, enter 9099. You should specify a
port number between 1000 and 65530 for compatibility with HTML-based configuration
capability, which can be accessed via the MAP or a standard Web Browser.
7.5.3 Select Printer Languages
Selection 2 in the Main Menu allows you to designate which emulations (printer interpreter
languages) the printer supports. This is to allow the resident lpd/lpr to modify files intended
for other emulations so that they may be printed. The menu also allows you to enable or
disable banners attached to lpd/lpr handled jobs.
The emulation choices are Printer Control Language (PCL), PostScript (PS), ASCII (simple
text) and Other (any print job not recognized as PCL, PS, or ASCII). The file modifications
and conditions are:
Print Server Setup Job Detected to be Action
PCL, (PostScript) ASCII <CR> changed to
<CR><LF>
PostScript PCL, Other PostScript header added
not PostScript PostScript Job discarded
PostScript ASCII PostScript header added,