Ricoh AP1400/AP2000 - Manual (Page 42)

Installing Options
22
2
Note
❒ Keep the paper tray with paper
in a cool and dry place.
C
While lifting the front side of the
envelope feeder, place the feeder
into the printer. Then slide it into
the printer until it stops.
Note
❒ When loading envelopes, see
P.92 “Type 2 Printer: Loading En-
velopes”.
Type 2 Printer: Installing the
Network Interface Board Type
2000
Note
❒ Please refer to the inside of the
front cover of this manual to con-
firm which printer (Type 1 Printer
or Type 2 Printer) you have.
❒ Use the shielded twisted-pair
(STP) network interface cable.
A
Check the contents in the box for
the following items.
• Network interface board
• CD-ROM
• Ferrite Core
• Installation Guide
• Quick Configuration Guide
• Additional Documentation
B
Be sure to check the following
points:
• The printer's power switch is
turned off.
• The power cord is unplugged
from the wall outlet.
C
Remove the back plate.
Note
❒ A coin can be used to remove
the screws.
D
Align the screw holes of the net-
work interface board over the
screw holes where the back plate
used to be. Make sure that the
board is aligned so that the jack is
facing out and is on the bottom.
Press the board firmly against the
printer. The interface connectors
on the printer and the board
should align and offer a slight re-
TS4Y290E
TS4P030E