Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 109)

Reference
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory Init.
Memory Switches
Comm. Method
Key Press Sound
Buzzer Sound Host Link
OFF
Putting-Out Time
Resume Function
OFF
None
ON
[ MEMORY SWITCH MENU (1/2) ]
Support Tool Mode NT600S
EXIT
SAVE
EXIT
NEXT
PAGE

2
    
Section 3-8
Types of the Buzzer Sounds The following buzzer sounds can be set.

Continuous sound: The buzzer continues to sound.

Intermittent sound: The buzzer sounds intermittently at constant intervals.
If both the continuous buzzer and the intermittent buzzer are instructed by the
Host, the continuous buzzer will sound.
Setting the Buzzer Use the memory switches to set whether or not the buzzer sounds when the buzz-
er sound has been instructed by the Host or with a screen attribute or when an
error has occurred.
The factory setting has been made at “ON” so that the buzzer will sound when a
command is received from the Host or when a screen attribute setting error has
occurred.
Set the buzzer sound by the menu operation from the System Menu as mentioned
below.
Select “Maintenance Mode”.
Select “Memory Switches”.
Repeatedly pressing the “Buzz-
er Sound” touch switch cycles
through
the setting options
“ON”, “ERR ON”, and “OFF”.