Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 176)

Reference
 
   
& ' ( 0  ' ( 0 "& 
  
 
Section 5-1
6-1-5 Notifying the Display Screen to the PC
(To Display the Number of Currently Displayed Screen)
The following describes the processing to display the number of currently dis-
played screen of the NT600S.
This processing reads the data from the PC status notify area.
To indicate that the screen has switched, use the screen switch strobe flag.
To display the number of the currently displayed screen, use the currently dis-
played screen word.
When the screen has switched, the NT600S notifies the following to PT status
notify area (PT to PC) allocated to the PC.
Screen switch notification: Screen switch strobe flag of the PT status word
New screen number: Currently displayed screen word
By reading the currently displayed screen word when the screen switch strobe flag
has turned ON, the number of the currently displayed screen on the NT600S is
displayed.
NT600S PC
Currently
displayed
screen
PT status notify area
Currently displayed screen Screen number
Content upgrade memory table
PT status Screen switch
strobe flag
[Currently displayed screen] and [PT status] words in the PT status notify
area
Use a 4-digit BCD (binary-coded decimal) value to set a screen number.
The screen switch strobe bit reverts to OFF (0) after this is notified to the PC.
Since the special auxiliary relays of the CV series PCs are allocated to the system,
they cannot be used for purposes other than the system use.
The range of respective area varies with the type of PC. Refer to Appendix L PC
Memory Map (page 291).
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0 Bit
-- 0 -- -- 0 0 0
Word
m
15 14 13 12 11 10 9 8 Bit
Screen number (4-digit BCD)*
PT status 0 0 PT status
* Screen number: 0001 to 1000
m+2
m+2
Screen switch strobe
Screen switch setting