Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 97)

Comm. Method
Key Press Sound
Buzzer Sound Host Link
OFF
Putting-Out Time
Resume Function
OFF
None
ON
[ MEMORY SWITCH MENU (1/2) ]
Support Tool Mode NT600S
EXIT
SAVE
EXIT
NEXT
PAGE

     
   -  $0&  1   .
 -  
Section 3-6
4-6 Setting the Conditions of Communications with the PC/
Host by Using the Memory Switches
The communications between the NT600S and a PC/Host are called the host
communications.
The NT600S can be connected to a PC/Host by the host link, NT link (1:1, 1:N),
C200H direct, or RS-232C. The link can be selected by setting the memory switch.
Also, the host link baud rate, automatic reset function, RS-232C communication
conditions, etc. are set with the memory switches.
This section describes the communications condition settings by using the
memory switches.
Memory Switches The NT600S has the memory areas used to store the PC/Host connection meth-
od, communications conditions, system settings, etc. which can be used as the
switches and called the “memory switches”. Since the memory switches use the
flash memory, the stored data can be held even when the power supply is turned
OFF.
If for any reason the set memory switch data is destroyed, a message will be dis-
played on switching to the run mode. If this happens, press the [Write] touch
switch to initialize the memory switches.
Setting Functions and the Memory Switch Menu
The memory switches can be set easily by using the memory switch menu in the
System Menu.
The functions that can be selected (memory switch menu) differ according to the
communication method selected, as shown on the next page. For details on each
function, refer to the next section onward and to 3-8 “Various System Settings”
(page 93).
[MEMORY SWITCH MENU 1 (When LCD display screen is used.)]
Comm. Method Selecting the Host Communication Method (page 85)
Key Press Sound 3-8 Various System Settings (page 93)
Buzzer Sound 3-8 Various System Settings (page 94)
Putting-Out Time 3-8 Various System Settings (page 96)
Resume Function 3-8 Various System Settings (page 98)
Support Tool Mode 3-8 Various System Settings (page 99)