Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 95)

Reference
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
EXIT
[ TRANSMIT MODE ]
Support Tool Mode: NT600S
EXIT
[ TRANSMIT MODE ]
Tool
→
PT
Screen Data
0 KB
Support Tool Mode: NT600S


  
  
  
Section 3-5
By setting the Support Tool Mode to “NT600M”, the NT600S is made compatible
with the existing NTM support tool. For details on setting the Support Tool Mode,
refer to page 99.
4. Enter the “Transmit Mode” by operating the menu of the NT600S as men-
tioned below.
Select “Transmit Mode”.
5. Select a screen data to be transmitted to the NT600S in the File Selection
screen of the support tool, and press the Send key.
6. The NT600S will display the following screen when the screen data is being
transmitted.