Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 132)



   
  
  
Section 4-1
[Exiting the Edit screen]
Return to the “Screen List”.
[To the File Selection]
Enter filename to newly created screen data.
Return to the “File List”.
Pressing the [F8] (Start-up screen) key allows setting of the screen number to be
displayed when the NT600S is booted. (Only effective when using RS-232C)
Transmitting Screen Data to the NT600S
Transmit the screen data created by using the support tool to the NT600S screen
data memory.
Connect the NT600S to the support tool and set the NT600S to Transmit Mode.
Then, press the [F6] (Transmit) key in the “File List” screen to transmit the created
screen data to the NT600S.