Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 121)

EXIT
[ TOOL TRANSMIT CHECK ]
Note
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory Init.
Memory Switches

  .  
Section 3-9

The data received from the connected support tool/Host are displayed in hexa-
decimal numbers.

When the check is finished, press the “EXIT” touch switch. Communication I/F
check menu will be redisplayed.
The NT600S uses one connector for connection to both the Support tool and the
PC/Host. If it is connected to other equipment, remove the connecting cable from
the connector and connect the cable to the connector for the Support tool/Host.
Then perform a communication check.
4-9-2 Checking the NT600S DIP Switch Settings
Display the NT600S DIP switch settings by using the menu operation from the
System Menu as mentioned below.
Select “Maintenance Mode”.
Select “I/O check”.