Omron NT-series Programmable Terminal V022-E3-1 - Manual (Page 114)

[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting Status
I/O Check
Display History
Memory Init.
Memory Switches
Comm. Method
Key Press Sound
Buzzer Sound Host Link
OFF
Putting-Out Time
Resume Function
OFF
None
ON
[ MEMORY SWITCH MENU (1/2) ]
Support Tool Mode NT600S
EXIT
SAVE
EXIT
NEXT
PAGE

2
    
Section 3-8
Starting from the system menu, make the following menu selections to set the
Support Tool Mode.
Select “Maintenance Mode”.
Select “Memory Switches”.
Each time the “Support Tool
Mode” touch switch is pressed,
the setting option changes from
“NT600S” to “NT600M” or from
“NT600M” to “NT600S”.
To set and quit the menu, press the [SAVE EXIT] touch switch. To quit without
setting, press [EXIT].

When “NT600M” is set, the NT600M compatible mode is established and the
NT600S can be used as if it were an NT600M.

When “NT600S” is set, the NT600S can be used as an NT600S.