Quantum Data 802BT - Manual (Page 126)

116 Chapter 8 Analyzing Digital Sources and Cables
6. Press the G key to display the following format parameters on the LCD.
Measuring detailed timing parameters
The analyzer can analyze detailed HDMI/DVI signal timing information. The timing
information is displayed on an HDMI/DVI display connected to the generator.
To view detailed timing information of an external HDMI/DVI source signal:
1. Connect the HDMI/DVI transmit device to the HDMI/DVI Rx connector on the generator.
2. Connect an HDMI/DVI display to the HDMI/DVI Tx connector on the generator.
3. If necessary, set the proper HDMI/DVI signal source parameters within the generator.
• See “ Starting the Analyzer Setup Utility ” on page 112 for steps on viewing the
current analyzer configuration.
• To edit HDMI/DVI signal source parameters, see “ Setting up analyzer to measure
timing ” on page 114.
4. If desired, monitor the video signal received on the HDMI Rx connector (see page 110).
5. Using the Format knob, select an appropriate format for the connected HDMI/DVI
display.
Note: To automatically configure the Format knob list based on the EDID structure of
a DDC-compliant display, hold down the R key, then press and release the ACS key.
1040 800 56 120
666 600 37 6
Horizontal period (pixels)
Vertical period (lines)
Active pixels per line
Active lines
Vertical pulse delay (pixels)
Horizontal pulse delay (pixels)
Horizontal pulse width (pixels)
Vertical pulse width (pixels)