Quantum Data 802BT - Manual (Page 729)

802BT/802R Video Test Generator User Guide 719
2465 Pixel clock pulse gate = 1 and pixel depth = 8
The generator hardware configuration does not support outputting a pixel clock output
when the video format’s pixel depth is eight bits-per-pixel.
2466 Pixel clock pulse gate = 1 not allowed
The generator hardware configuration does not support a pixel clock output.
2490 EQ before too large
The video format’s number of lines of pre-equalization for analog or digital composite sync
must not exceed the number of lines of vertical sync pulse delay.
2495 EQ after too large for interlaced format
The interlaced video format’s number of lines of post-equalization for analog or digital
composite sync must not exceed the number of scan lines from the end of the vertical
sync pulse to the start of video for either field.
2496 EQ after too large
The non-interlaced video format’s number of lines of post-equalization for analog or digital
composite sync must not exceed the number of scan lines from the end of the vertical
sync pulse to the start of video.
2550 Not enough video memory
The generator hardware configuration does not have enough video memory to support the
video format’s combination of active pixels per line (HRES setting) and active lines per
frame (VRES setting).
2551 Insufficient memory
Not implemented at the time this document was created.
2553 No PCMCIA card found in drive
When attempting to download a bitmap no PCMCIA card was detected in the generator’s
PCM slot.
2554 PCMCIA card is write-protected
When attempting to download a bitmap to a PCMCIA card, the PCM card was
write-protected.
2555 PCMCIA card is bad
When attempting to download a bitmap to a PCMCIA card, the PCM card was found to be
bad.