EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 108)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
98
Next
While the playlist is rolling on air, selecting the Next function will start the transition of the
next clip with the transition effect listed on the playlist. This can be used if a clip is running
too long and it is necessary to shorten up the playing time.
Skip
While the playlist is rolling, the next clip in the sequence is always displayed on the PRV
screen. The Skip function allows the operator to discard clips before they go on-air. The
clip that will be «skipped» is the one displayed on the PRV screen. This function does not
remove the clip from the playlist, but it simply allows it to be skipped during playback.
Edit
Selecting the Edit function gets the user back to the Playlist Edit mode.
11.9 Overview of Editing Functions in Playlist Edit
Mode
The following section presents the various editing functions available from the main and
secondary Playlist Edit Mode.
11.9.1 Main Menu in Playlist Edit Mode
Introduction
The main menu in the Playlist Edit mode is available when you select the location of the
requested playlist, and press PLST on the Remote Panel:
Effect Edit All
Insert Speed FX Dur Delete
In the Playlist Edit mode, the first frame of the playlist element loaded (highlighted on the
Remote Panel LCD display) can be seen on the PGM. To change any of the options on a
clip, simply browse to the requested clip, then select a function from the menu displayed
above and use the control lever to adjust to the desired value (when applicable).
Edit All
If you want to edit all clips of the playlist at the same time, select Edit All (SHIFT+D)
before you perform the requested editing action with one of the following playlist
commands: Speed, Effect, FX Dur.