EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 109)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
99
Insert
The Insert function (A key) allows the operator to insert a clip into the playlist. The same
operation can be achieved using the TAKE key.
See also the section 11.10.4 ‘How to Insert Clips into a Playlist’, on page 102.
Speed
The Speed function (B key) allows defining the speed at which one or all clips of a playlist
will be played. Select the playback speed of the clip with the lever, then press ENTER to
validate. Values are ‘Unknown’ and from 0 to 100%.
Operators have access to the secondary lever control like when clips are replayed. While
editing the speed of a clip, pressing SHIFT+Lever on the Remote allows to access the
secondary lever speed defined in the menu.
FX Dur
The FX Dur function (C key) sets the duration of the transition effect. The default value
that initially appears is determined by the value set in the Setup menu. The effect
duration will affect the transition at the beginning of the selected clip. Use the lever to
adjust the value, then press ENTER to confirm.
Effect
The Effect function (SHIFT+C key) is used to select the type of transition effect
(Mix/Wipe/Cut/Fade). Move the lever to set the type of effect, when Effect is highlighted.
Press ENTER to validate.
For more information on the effects types, refer to the section 11.15 ‘Transition Effects’,
on page 113.
Delete
The Delete function allows the operator to quickly edit a playlist by removing the selected
clip. The clip that has been «cut» can then be inserted into another location. This clip is
displayed on the second PRV output. To insert it at another position in the playlist, simply
go to that position using the jog dial and press the Insert key (or TAKE).
11.9.2 Secondary Menu in Playlist Edit Mode
Introduction
You can access the secondary menu of the Playlist Edit mode pressing MENU on the
Remote Panel when you are in the main menu of the Playlist Edit mode.
Clr Unav.
OtherAng Add cut
Replace MakeLoc Redo Undo