EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 26)

Issue
11.00.C
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
16
When the current picture on the primary channel is neither a clip nor a cue point, or if the
operator is in Playlist mode, pressing the BROWSE key allows him to browse inside the
clips of the current playlist by turning the jog dial.
4.1.12 INSERT
This function inserts a clip before or after (depending on the Setup menu) the current
position inside the playlist.
4.1.13 ENTER
This function appends clip(s) at the end of the current playlist. This is also used to confirm
saving of clips, and validate various options and messages.
4.1.14 MENU
This function allows the operator to gain access to the secondary menu.
SHIFT+MENU on the Remote gains access to the main menu.
Also used as an
ESCAPE key to cancel some options and messages.
4.1.15 CLEAR
This function clears the IN / OUT/ playlist / CLIPS / CUE points.
Note
• To clear one CUE point, recall the desired cue point and press
CLEAR+MARK key.
• To clear all cues: when current picture is not a CUE point, press
CLEAR+MARK key. A message appears to confirm the command.
4.1.16 NETWORK
This function gives access to the clips and/or records trains of other machines on the
network. After the selection of the machine, the way of selecting clips and camera angles
is similar to clips selection on the local LSM system. Refer to the Chapter 13 ‘Operating
on XNet Network’, on page 147 for more details.