Photron camera, Application start, Configuration parameter values – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 193: Key behavior, Cue points management, 2 photron camera
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
183
18.5.2
Photron Camera
Application Start
At application start, this camera is in ARM mode and the recording starts on the first
memory block.
Configuration Parameter Values
The
PGMSpeed parameter value 1000 is available.
Key Behavior
•
TAKE: this key is operational in ARM mode.
•
RECORD: the remote does not beep if the CAM key refers to an empty block.
•
RECORD: pressing this key while the current block is recording does not send any
command to the camera.
•
CLEAR: this key has no effect.
Cue points management
•
When a new ARM/REC command is issued on a block, all its cue points are cleared.
•
If the
Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.
•
If the
Last Cue command refers to a TC that does not exist anymore, the player
jumps to the beginning of the current memory block.
•
Cue points can not be marked when working on several memory blocks.