Editing operations, Extend overwrite, Extend from in – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 153: Extend from out, 6 editing operations, 1 extend overwrite
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
143
12.6
Editing Operations
The timeline editing operations on the remote require marking IN and OUT points on the
recorder before performing the extend or insert actions. These IN and OUT points can be
marked anywhere on the timeline as in the Replace mode since the timeline is equivalent
to a record train.
12.6.1
Extend Overwrite
The Extend feature in Multicam consists in extending the length of a timeline element by
extending the IN or OUT points of a clip as explained below, as long as the material is
available.
If the required material is not available, the Remote Panel will beep. The Extend is always
performed in Overwrite mode, which means that the material ‘covered’ by the Extend is
deleted from the timeline.
Extend From IN
This editing action shifts the OUT point of the timeline element which includes the Mark
IN to the defined Mark OUT. The following schema shows an example with only the video
track selected.
Original Timeline
Extend from IN
111A
111B
146A
184C
111A
111B
146A
184C
111A
111B
146A
184C
V
A1
A2
111A
111B
184C
111A
111B
146A
184C
111A
111B
146A
184C
V
A1
A2
IN
OUT
Extend From OUT
This editing action shifts the IN point of the timeline element which includes the Mark
OUT to the defined Mark IN. The following schema shows an example with only the video
track selected.