Push, Introduction, Principle – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 55
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
45
If a keyword file is selected in the setup, the LCD display will be:
In this mode of the secondary menu, the
F1-F10 keys are used for keyword assignment,
and thus can no longer be used to recall clips. For a description of the keyword-related
functions, please refer to the “Keyword Management” Section of this manual.
The ID of the current clip appears on the end of line 3 of the LCD display.
Push
Introduction
The
Push function allows you to easily send a copy of a clip to another machine on the
network,
either via the GigE network or the SDTI network.
Principle
•
If one or two default targets (push machines) are defined in the setup, the clip will be
automatically sent to these machines.
•
If no default target is defined, the list of machines available on the network will
appear. As soon as the operator selects one of them, the clip is pushed.
Depending on the push settings defined, the default targets or the list of possible targets
submitted to you will contain EVS servers on the SDTI network and/or EVS servers on
the GigE network.
For more information about the
Push settings, refer to the Operational Setup menu on
the Remote Panel, page 7.1.
In both cases, a message appears for a few seconds on the LCD to confirm that the clip
is being pushed and indicate the clip location where it will be stored on the receiving
machine.
If the Receive Page(s) defined on the destination machine is (are) full, the operator who
tries pushing the clip is notified. While this message is being displayed, the operator can
press the
MENU key at any time to return to the normal menu. Depending on the
CAM/CLIP mode selected by the
D key, only the camera angles loaded on the controlled
channels are pushed (CAM mode), or all camera angles of the clip are pushed at once
(CLIP mode).
1 keyword890123 2 keyword89012
3 keyword89012
F1:action_1 F6:action_6
F2:action_2 F7:action_7
111A
F3:action_3 F8:action_8
F4:action_4 F9:
p.01
F5:action_5 F0:Next page
Push
Aux Clip
Sort->TC
Post-Roll
>Archive
***
Name
Cam