EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 53)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
43
Clip Mode/Cam Mode
Pressing the D key in the Copy/Move LCD window allows the user to select a value for
this setting:
• CLIP mode: all camera angles of the clips will be copied/moved.
• CAM mode: only the camera angles of the clip loaded on the controlled channels will
be copied/moved.
Short/Long Mode
This option is only available for a network copy, not for a local copy or for a move.
Pressing the
C key in the Copy/Move LCD window allows the user to select a value for
this setting:
• SHORT mode: only the material between the Short IN and Short OUT points of the
original clip, augmented by the duration of the guardbands defined on the destination
system, will be copied.
• LONG mode: the entire original clip, including its guardbands, will be copied to the
destination system.
Default Settings
The default settings for the COPY/MOVE menu are: COPY, SHORT, CLIP. If the operator
changes these settings, the new settings will be re-used the next time this menu is called.
The default settings will be automatically restored when starting a new Multicam session.
How to Copy or Move a Clip
It is possible to copy or move a clip on the same server or to another server. Growing
clips can also be copied and moved.
To copy or move a clip from the Remote Panel, proceed as follows:
1. Select the original clip.
2. Select an empty location on an EVS server connected to the network.
A new menu appears on the LCD display of the Remote Panel, with the
corresponding message on the OSD of the output monitors:
3. Select the COPY or MOVE function by pressing the A or B key.
The corresponding function will be highlighted on the LCD and the message on the
OSD will be updated accordingly.
4. Select the CLIP or CAM mode with the D key.
5. Select the SHORT or LONG mode with the C key.
Copy Clip 113 to Clip 141
Cam A B
[Menu]: Cancel
[Enter]: Confirm
COPY MOVE SHORT CLIP