EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 115)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
105
3. Press SHIFT+C to search and load the local and distant record trains that include the
same TC IN as the playlist element.
The first record train is loaded on the PRV channel, at the current TC of the loaded
element.
4. Press Browse and use the jog to move within one record train to browse its content.
5. Once you have loaded the requested camera angle on the PRV channel, press
ENTER.
This will replace the current playlist element by a new clip having the same TC IN and TC
OUT. The new clip is stored on the playlist receive page. The effects, the split audio and
the swap points defined on the initial playlist element are preserved.
11.11 Copying Playlists
11.11.1 Introduction
From the VGA Clip screen, you can perform cut, copy and paste actions with playlists, in
the same way as you do with clips. For more information on these actions, refer to the
section 9.3.13 ‘Moving and Copying Clips’, on page 61.
From the Remote Panel, you can only copy a playlist, but not move (cut & paste) it to
another location.
11.11.2 Copy Options
When you copy a distant playlist from the VGA, or a local/distant playlist from the Remote
Panel to the local EVS server, you have different options:
EDL only or EDL+Clips Copy
• The EDL copy copies only the playlist definition and the playlist elements themselves
remain at the original location.
• The EDL+Clips copy copies the playlist definition and the playlist elements to the
server on which the copy is requested.
Long or Short Copy
When you copy the material of the playlist elements, you can perform a long or short
copy:
• The short copy copies the material between the IN and OUT points of the playlist
elements, with clip guardbands as defined on the destination system.
OtherAng
Replace MakeLoc