EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 161)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
151
13.4.4 How to Insert Remote Clips into a Playlist
To insert remote clips into a playlist, proceed as follows:
1. Select the Remote LSM via the
Network menu.
2. Select a remote clip in the banks.
The corresponding F_ key lights red.
3. Press ENTER on the Remote.
4. Repeat the three first steps as many times as necessary until the last clip is entered.
In Playlist Edit mode, the remote display gives all needed information regarding this
playlist and this information is updated each time a clip is stored in the playlist.
13.4.5 How to Roll a Playlist with Remote Clips
To roll a playlist with remote clips, proceed as follows:
1. Once the playlist is cued and ready to roll, select the playlist from the playlist bank.
2. Press the
PLST key on the Remote Panel.
3. Move the lever to start the playback or press the PLAY key.
Clips Unavailable on the XNet Network
While the playlist is rolling on air, a remote clip might be unavailable due to a network
problem or simply if the Remote LSM has left the network. In this case, the clip is marked
as ‘NOT AVAILABLE’ on the playlist screen and is skipped when the playlist is rolling. If a
clip is available again, it will re-appear automatically and be played at the right position in
the playlist.
Unavailable clips are shown on the VGA monitor but not on the LCD of the remote.
The operator can decide to definitively remove the unavailable clips from all local playlists
by using the Clr Unav. function (SHIFT+B) in Playlist Edit mode. Note that this function is
only visible when unavailable clips are present and with Split Audio Editing turned off.
PL11 LSM01 MICHEL LOC TDUR=00:00:58:22
152A/03 Clip 0112 00:01:20 Unk W00:10
111A/04 Clip Foot 00:10:25 Unk W00:10
112B Clipname4567 00:04:29 Unk W00:10
112B/02 Clip 0113 00:01:10 Unk W00:10
552C/08 noname01234 00:02:50 Unk W00:10
EFFECT EDIT ALL
INSERT SPEED FX Dur DELETE