Results, Examples, How to shorten a clip – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 59: Goto in and goto out, Restriping the timecode of a clip, Restrictions on the remote panel, 10 how to shorten a clip, 11 restriping the timecode of a clip
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
49
Results
If matching clips are found, the Remote Panel will automatically be in Browse mode (the
BROWSE key is red), allowing the operator to quickly view the frame of each clip
corresponding to the requested timecode by rotating the jog dial.
To be able to jog inside a clip, disable the Browse mode by pressing on the
BROWSE
key and move the jog dial. To return to the Browse mode inside the search results, press
the
BROWSE key again.
Search results are reset when going by to LIVE mode, or when a new search is
performed.
Examples
•
You have loaded the picture of an interesting event, and you want to see all clips that
contain that same event. Call the Sort ->TC function, select the network/local search
option and launch the search. Move the jog dial and you will see the same event on
the same timecode from all available camera angles that have been clipped.
•
You know the timecode of a particular event and you want to see all clips containing
that event. Call the Sort ->TC function, edit the timecode to the desired value, select
the network/local search option and press
ENTER: you will obtain the same result as
above if the timecode belongs to the same type as the one previously mentioned.
9.2.10
How to Shorten a Clip
To shorten a clip, proceed as follows:
1. Recall the desired clip by pressing the corresponding
F_ key.
2. Move the jog dial to browse the clip and reach to the desired Short IN point.
3. Press the
IN key to mark a new Short IN point. The new Short IN point is instantly
saved.
4. Move the jog dial to reach the desired Short OUT point.
5. Press the
OUT key to mark a new Short OUT point. The new Short OUT point is
instantly saved.
Move the lever or press the PLAY key to play the clip. The replay will stop at the new
Short OUT point (or after the Short OUT point if the Post-Roll mode is enabled).
GOTO IN and GOTO OUT
You can use
Goto IN and Goto OUT functions to jump immediately onto Short IN or
Short OUT points respectively.
9.2.11
Restriping the Timecode of a Clip
Restrictions on the Remote Panel
The function to restripe the timecode of a clip via the Remote Panel is more restricted
than via Multicam on the VGA:
•
You cannot choose which timecode type you modify: you will automatically modify the