Full control and lever control, 2 full control and lever control – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 39
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
29
Press this function to enter the 2nd CTRL menu, select the channels that you want to
pass to the secondary controller by pressing the corresponding
A or B key, then press D
(DONE) to validate your selection. Do the same to bring the control of a channel back to
the EVS remote.
6.2
Full Control and Lever Control
Controlling both PGM and PRV is done when PRV CTL (direct access key from the
remote) is not activated.
Once selecting PRV CTL, the operator will have control of the PRV with the jog dial and
most buttons, while the lever and the
Play button will control the PGM output. At this
point, selecting clips will call them up on the PRV side.
The combination of the PRV CTL and the SW to IN functions allows the operator to auto-
chain cameras from the same IN point.
When an IN point has been marked, the operator activates the
PRV CTL and sets ON the
SW to IN option. Then the slow motion of one camera can be started from this IN point.
The operator selects another camera in the PRV output and, via the
TAKE button, can
auto-chain cameras from the same IN point on the PGM output.