Set tc, Name, Search – EVS MulticamLSM Version 11.00 Operating Manual User Manual
Page 57: Post-roll, Clip/cam
Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
47
‘How to Search for Clips by Timecode’, on page 48.
Set TC
The Set TC function is only available in SHIFT+B on the Sort->TC menu. It allows the
operator to restripe the timecode of a clip. This function is explained in details in the
section 9.3.12 ‘How to Restripe the Timecode of the Current Clip’, on page 60.
Depending on the mode selected with the
D key (CLIP/CAM), the new timecode value is
assigned only to the camera angle of the clip loaded on the primary channel (CAM
mode), or to all camera angles of the clip (CLIP mode).
Name
The Name function is only available if a keyword file is selected in the Setup menu. It is
used to name a clip based on available keywords. Refer to the chapter 10 ‘Keyword
Management’, on page 70 for more details. When the Name function is selected, pressing
SHIFT+C again will call the Search function.
Search
The Search function is “hidden” behind the Name function. Press SHIFT+C again in
Name mode to call it. It allows the operator to search the database for clips based on
keywords and ranking. Please refer to Chapter 10 ‘Keyword Management’, on page 70
for details.
Post-Roll
This function enables/disables the Post-Roll mode. This mode is explained in details in
the section ‘PostRoll’, on page 26.
Clip/Cam
Pressing the
D key will toggle between CAM and CLIP modes on the remote. Please note
that this mode on the remote and on the VGA screens is never synchronized. In CAM
mode, the Push, Archive, Ranking assignment, Keyword assignment, and Name
functions will apply only to the camera angles of the clip loaded on the controlled
channels. In CLIP mode, these functions will apply on all camera angles of the clip.