EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 19)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
9
without having to return to the Setup menu.
• To return to the operational menu, press the MENU key again.
• To return to the Main menu in Multicam, press SHIFT+MENU.
2.5 Transport Controls
2.5.1 Jog Dial
The jog dial allows the operator to pass into Search mode and thus to choose
exactly the Short OUT or Short IN image. Move the jog dial clockwise to search forward
and move it counter-clockwise to search backwards. One revolution of the jog dial will
produce a jump of approximately 35 frames. This number can be multiplied by enabling
the Fast mode. The multiplication factor is defined in the Setup menu.
Note
The jog dial is also used to do the following:
• set parameters in the Setup menu. Refer to the ‘Setup Menu’ section for
more information.
• browse inside the clips database, the cue points or the current playlist. Refer
to the explanation of the BROWSE function for more details.
The jog dial is active at all times when the system is in Play & Record modes.
2.5.2 Lever
The lever is used to start a play or to modify slow motion speed. Its run can be of
two different types depending on the lever mode. In this mode, the lever run goes from 0
up to 100%.
Different ranges are available to play material from –400% to 400% using the
Second
lever range parameter in the Operational Setup menu (p.9.1 F5).
To access this second speed range, press SHIFT+LEVER from the remote controller.
Note
When SD SUPER MOTION material is loaded on the primary channel, the lever
range has a larger, flat step at 33%.
With HD SUPER MOTION, the step is at 33% or 50% depending on the
camera.
The lever is also used to adjust speed, effects type and duration in Playlist Edit mode.