EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 143)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
133
the Go to In button on the Remote. The next swap point is reached by pressing the Go to
Out button. The function works in loop mode.
11.18 Replace Function
11.18.1 Introduction
The purpose of the Replace function is to automate a routine used by operators to create
effects in a playlist: the operator would loop a section or an entire playlist back to
themselves and, during the playback, add some effects externally (graphic insertion for
instance) or internally (changing the speed).
While the operator would play the playlist back, and insert the requested effects, the
playback result would be re-injected into the playlist from a predefined IN frame. The OUT
point of the replaced section would be predefined or manually defined in the record
process.
Note
The Replace function is not allowed on playlists containing growing clips.
11.18.2 Entering the Replace Function
A secondary menu with the Replace function has been added to the Playlist Edit mode.
Pressing MENU in Playlist Edit mode brings up the following menu:
Clr Unav. OtherAng
Replace MakeLoc Redo Undo
Select Replace in this secondary menu to enter the Replace function.
11.18.3 Replace Edit and Replace Playback Modes
Similar to the playlist, the Replace function has two modes:
The Replace Edit Mode
This mode allows to specify the following information for the Replace:
• IN point and OUT point, for the section to replace in the playlist. The OUT point can
also be defined during the Replace itself.
• Loop mode parameters. See also the section ‘Loop Mode in the Replace Function’,
on page 135.
In the Replace Edit mode, the playlist is considered as one entity on which you can mark
one IN point and one OUT point (pressing the IN and OUT points does not retrim the
current playlist clip).
Those IN and OUT points will be used to determine what portion of the playlist will be
replaced.