EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 69)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
59
9.3.10 Recalling a Clip
How to Call a Clip Belonging to the Machine You Are
Connected to
The machine to which you are connected is indicated on the left side of the Title Bar.
To call a clip belonging to the machine you are connected to, proceed as follows:
1. Type either the 3 or 4 digits of the ID. Ex: 111 or 111A. The entry appears in the
Name field.
2. Press F3
• If only 3 digits are entered, the primary camera is selected
• If 4 digits are entered, the clip is selected according to the given camera angle.
• If no clip matches the entry, no selection is done.
Note
ESC key can still be used at any time to clear the Name field.
How to Call a Clip Belonging to Another Machine Than
the One You Are Connected to
To call a clip belonging to another machine than the one you are connected to, proceed
as follows:
1. Type either the first 3 or 4 digits of the ID, followed by a “/” and the network number of
the machine. Ex: 111/03 or 111A/03. To call a local clip, no matter what machine you
are connected to, type 00 as network number. Ex: 111/00 or 111A/00.
2. Press F3.
9.3.11 How to Cancel a Network Copy on the VGA
Select the clip and press the CTRL+DELETE keys. A confirmation screen comes up.
“Cancel network copy? ESC: Do not cancel copy - ENTER: Cancel copy”
If the Copy Clip option copies several cams of the same clip and some of them have
already been copied before the Cancel function, the Cancel does not delete the copied
files, it just cancels the cam(s) that are still copying or to be copied of that clip. It does not
cancel the copying of other clips.
The Cancel function remains possible even if the page where the clip is being copied is
protected.