EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 187)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
177
RECORD
This key corresponds to the ‘ARM’ or ‘REC’ commands on hypermotion cameras.
When you press RECORD for the first time, all the A/V material recorded in the memory
block(s) of the camera is deleted.
Please refer to the camera models specific features at the end of this chapter for more
information about the behavior of your camera when pressing the RECORD key on a
recording memory block.
TAKE
This key corresponds to the ‘Trig/Stop Rec’ command on hypermotion cameras.
With a single-block memory or when the last block is reached, press TAKE to stop the
recording.
With a multiple-block memory, press
TAKE to stop the record on the current block and
automatically start the record on the first free block, if available.
Lever
There is no corresponding command on hypermotion cameras.
Press the
Lever key to shift to the secondary lever range (defined in the 2ndLever
parameter in the hypermotion secondary menu) for material played out using the
hypermotion feature.
CAM Keys
Press a CAM key corresponding to a recorded block to load the last recorded frame of
the selected block in play mode.
If you press a CAM key corresponding to an empty block, the remote beeps.
CLEAR
Note
The CLEAR button is only active on some cameras.
Press the
CLEAR key to clear the recorded material on a block. It can be used in the
following ways:
• To clear the record on a given block that is not in PLAY mode, press CLEAR and the
CAM key corresponding to the requested block.
• To clear the record on a block when the block is in PLAY mode, press CLEAR. The
PLAY is stopped, the recorded material is deleted from the block, and the camera
automatically starts recording again in this block if it is not recording on any other
block yet.