EVS MulticamLSM Version 11.00 Operating Manual - Manual (Page 145)

Multicam - Version 11.00 – Operating Manual
EVS Broadcast Equipment SA – April 2012
Issue
11.00.C
135
requested point and press the OUT key. Otherwise, you can define the OUT point
while you perform the Replace.
6. Press the B or C key to select whether you will use the internal loop or external loop
to perform the Replace.
For more information on the loop type and additional parameters, refer to the section
‘Loop Mode in the Replace Function’, on page 135.
The playlist is cued before the IN point (to create guardbands), ready to be initiated.
A message appears on Remote: “ Start Replace: lever or play button”.
7. Push the lever or press the Play key on the Remote Panel to shift to the Replace
Playback mode and start the Replace process.
8. If you have not defined the OUT point for the Replace in step 5, press the OUT key
when you reach the desired OUT point.
While the Replace is being performed, the following messages are displayed on the
OSD:
“Replace in Progress”
“Clipping guardbands”
“Replace by clip xxx”
On the Remote Panel, a confirmation message pops up:
9. Press Enter on the Remote Panel to validate the Replace:
The material between the IN and OUT points is replaced with the newly created clip.
The playlist returns to Playlist Edit mode, positioned at the end of the inserted clip.
You can also cancel the Replace by pressing the Menu key on the Remote Panel.
11.18.6 Loop Mode in the Replace Function
Loop Type
When the IN point has been marked, the display switches to:
Cam A +2fields
Replace Int.Loop Ext.Loop
The Int. Loop and Ext. Loop keys are blinking.
Before entering the Replace Playback mode, the operator has to choose between Internal
Loop or External Loop.
The Internal Loop is the same loop as the existing loop process.
The External Loop allows you to select on which channel you will physically re-record the
output of your PGM. The link is physical: it is necessary to make the video link manually
with a router or video/audio cables; it is not done inside the server.
Replace in/out by clip xxx ?
MENU: Cancel – ENTER: OK.