Installation procedures, Step 2 - mounting the aquavar controller, Warning – Xylem IM043 AQUAVAR Variable Speed Pump Control User Manual
Page 11
10
Step 2 - Mounting the AQUAVAR controller:
1. The AQUAVAR controller drive head
is supplied with all mounting
hardware.
2. Remove the 3 screws from the
AQUAVAR cover.
3. Place the center bit in the
AQUAVAR heat sink.
4. Place the AQUAVAR on the motor.
5. Hang the 4 clamps by the heat
sink and mount with the 4 screws.
6. Mount the cover with the 3 screws
(remember to use the gaskets).
7. Depending on pump orientation,
the display can be rotated 180º.
Installation Procedures
Gasket
4 screws
M5x50
Transducer
Display
changeable
to 180º
Connection
motor
conduit box
Thermistor
4 mounting
clamps
Diagram 4
THE AQUAVAR CONTROLLER DRIvE HEAD AND PuMP MuST BE TOTALLY DISCONNECTED
FROM ALL POWER SuPPLY SOuRCES BEFORE BEgINNINg INSTALLATION OR REPAIR.
WARNINg
FAILuRE TO DISCONNECT ELECTRICAL POWER BEFORE ATTEMPTINg ANY MAINTE-
NANCE CAN CAuSE SHOCk, BuRNS, OR DEATH.
WARNINg!
WARNING
hazardous voltage
can shock, burn or
cause death.