Programming, Instructions, Screen – Xylem IM043 AQUAVAR Variable Speed Pump Control User Manual
Page 54: Returning to normal operation
53
multiple Pump Pump Protection... continued
Instructions
3. Error Reset Turning this control on will
enable the AQUAVAR controller to retry its
operation five times when a fault condi-
tion occurs. Turning the control to “off”
means that the AQUAVAR controller will
shut down the first time a fault occurs.
• Press
to advance the display to:
• Use the
to select the mode you want.
Returning to normal operation:
4. Hold down the
key for 2-3 seconds
until the display changes to:
• Scroll past the next few screens (briefly
touch the key) until you reach:
5. Save the new settings by pressing the
at the same time until the display changes to:
After a moment, the screen will automatically return to the main menu start position.
6.
Repeat steps 1 through 5 above for each of the other pumps in the system which
have suction switches or float switches.
Programming
ERROR RESET
Screen
SUbMENU ERRORS
t
t
SAVE ??? +
SAVE ??? SAVED
t
t
t
t
“Fatal” errors will always shut down the system the first time.
Note
*
*
*