Xylem IM043 AQUAVAR Variable Speed Pump Control - Manual (Page 14)

electrical Connections continued
Step 3 - Wiring the AQUAVAR controller to motor
(Parts in the electrical fittings package will be required for this procedure.) Refer to Diagram 3
before proceeding.
1. Remove the three screws holding the top of the AQUAVAR controller. Carefully lift off the cover
of the AQUAVAR controller.
2. Remove the screw holding the ground wire to the inside of the top of the AQUAVAR controller.
Set cover aside.
3. Motor Lead Connections
Locate the terminal block labeled U, V, W, and ground screw inside the AQUAVAR controller
(Diagram 5).
Connect wires to terminal block and route wires through one of the ports on the
bottom half of the AQUAVAR controller. (Refer to Diagram 5).
13
Installation Procedures