Xylem IM043 AQUAVAR Variable Speed Pump Control - Manual (Page 8)

7
3. Installation and maintenance MUST be performed by properly trained and qualified personnel.
4. Review all instructions and warnings prior to performing any work on the AQUAVAR controller.
5. Any safety decals MUST be left on the AQUAVAR controller unit and pump.
6. In addition to instructions contained in this manual, you must meet any local safety, electrical, or
plumbing codes and requirements. Installation, maintenance, or repair work must only be
carried out by trained, skilled, and qualified personnel, using proper protective gear and
tools.
7. The AQUAVAR controller drive head must be disconnected from the main power
supply before attempting any operation in the electrical or mechanical part of the
system.
Safety Instructions
When in operation, the motor can be stopped, but power remains at the drive head.
The motor and pump could start unexpectedly and produce serious injury. When the
AQUAVAR controller drive head is connected to the main power supply, the inverter
power supply and master control unit are also connected to the power supply.
Inspect AQUAVAR controller for any damage after unpacking from shipping crates.
Report any damage immediately to the carrier or distributor/dealer immediately.
Note
Note
FAILuRE TO DISCONNECT ELECTRICAL POWER BEFORE ATTEMPTINg ANY
MAINTENANCE CAN CAuSE SHOCk, BuRNS, OR DEATH.
WARNINg!
WARNING
hazardous voltage
can shock, burn or
cause death.