Teledyne 6400EH - Sulfur Dioxide Analyzer - Manual (Page 21)

UV Fluorescence SO2 Analyzer Getting Started
Teledyne Analytical Instruments 9
Getting Started
3.1. Unpacking and Initial Setup
CAUTION: TO AVOID PERSONAL INJURY, ALWAYS USE TWO
PERSONS TO LIFT AND CARRY THE MODEL
6400EH.
1. Inspect the received packages for external shipping damage. If
damaged, please advise the shipper first, then TAI.
2. Included with your analyzer is a printed record of the final
performance characterization performed on your instrument at
the factory. This record is an important quality assurance and
calibration record for this instrument. It should be placed in the
quality records file for this instrument.
3. Carefully remove the top cover of the analyzer and check for
internal shipping damage.
 Remove the set screw located in the top, center of the rear
panel
 Remove the screws fastening the top cover to the unit (four
per side).
 Lift the cover straight up.
Note: Printed circuit assemblies (PCAs) are sensitive to electro-
static discharges too small to be felt by the human nervous
system. Failure to use ESD protection when working with
electronic assemblies will void the instrument warranty.
See Chapter 12 of the 6400E Manual (P/N 04515) for more
information on preventing ESD damage.