Teledyne 6400EH - Sulfur Dioxide Analyzer - Manual (Page 81)

UV Fluorescence SO2 Analyzer Appendix A
Teledyne Analytical Instruments 69
Appendix A-3: Warnings and Test Functions,
Revision C.0
Table A-2: 6400EH Warning Messages, Revision C.0
NAME MESSAGE TEXT DESCRIPTION
WSYSRES SYSTEM RESET Instrument was power-cycled or the CPU was reset.
WDATAINIT DATA INITIALIZED Data storage was erased.
WCONFIGINIT CONFIG INITIALIZED
Configuration storage was reset to factory configuration
or erased.
WPMT PMT DET WARNING
PMT detector outside of warning limits specified by
DETECTOR_LIMIT
variable.
WUVLAMP UV LAMP WARNING
UV lamp reading outside of warning limits specified by
DETECTOR_LIMIT
variable.
WSAMPFLOW SAMPLE FLOW WARN
Sample flow outside of warning limits specified by
SAMP_FLOW_SET
variable.
WSAMPPRESS SAMPLE PRESS WARN
Sample pressure outside of warning limits specified by
SAMP_PRESS_SET variable.
WVACPRESS VACUUM PRESS WARN
Vacuum pressure outside of warning limits specified by
VAC_PRESS_SET
variable.
WBOXTEMP BOX TEMP WARNING
Chassis temperature outside of warning limits specified
by BOX_SET variable.
WRCELLTEMP RCELL TEMP WARNING
Reaction cell temperature outside of warning limits
specified by RCELL_SET variable.
WIZSTEMP IZS TEMP WARNING
IZS temperature outside of warning limits specified by
IZS_SET
variable.
WPMTTEMP PMT TEMP WARNING
PMT temperature outside of warning limits specified by
PMT_SET
variable.
WDARKCAL DARK CAL WARNING
Dark offset above limit specified by DARK_LIMIT
variable.
WHVPS HVPS WARNING
High voltage power supply output outside of warning
limits specified by HVPS_SET variable.
WDYNZERO CANNOT DYN ZERO
Contact closure zero calibration failed while
DYN_ZERO
was set to ON.
WDYNSPAN CANNOT DYN SPAN
Contact closure span calibration failed while YN_SPAN
was set to ON.
WREARBOARD REAR BOARD NOT DET Rear board was not detected during power up.
WRELAYBOAR
D
RELAY BOARD WARN
Firmware is unable to communicate with the relay
board.