2) when the gateway unit is used, 31 3. installation and w iring, Acon-se controller – IAI America ACON-SE User Manual
Page 41
![background image](/manuals/350310/41/background.png)
31
3. Installation and W
iring
(2)
When the gateway unit is used
Caution: [1] The input current to the EMG terminal of ACON-SE is 5 mA. When connecting the
contact of the EMG relay R to the EMG terminals of multiple controllers, check the
current capacity of the relay contact.
[2] Make the 0V of the gateway unit power supply and ACON-SE power supply in
common.
Gateway unit
Gateway
power supply
Port switch
Teaching pendant
EMG push
button
T.P. connector
ACON-SE controller
EMG reset
switch
EMG
push
button
Input power supply
24 VDC
SIO
communication
SIO connector
SIO
connector
connection
detecting
circuit
Connection
detecting
signal (H)
Drive stop
signal (L)
Ti
m
e
const
ant
Control
power
supply
Power supply terminal block
Power supply terminal block (Unit 2)
EMG signal
detection
(H)
Motor drive
power
supply
Motor
drive
circuit
Power supply terminal block (Unit 3)