Vanguard EZCT-S2A User Manual
Page 38
EZCT S2A USER’S MANUAL
REV 1
34
3.3.4. Printing a Directory of Test Records Stored in the EZCT S2A’s Memory
You can print a directory of all the test records stored in the EZCT S2A’s Flash EEPROM using the
steps below:
a. Start from the “START-UP” menu:
Press the
[2]
key (SETUP).
b. The following screen will be displayed:
Press the
[3]
key (RECORD DIRECTORY).
c. The following screen will be displayed:
NOTE
The above screen will be displayed only if a USB Flash drive is NOT connected
to the EZCT S2A’s USB Flash drive port. If a USB Flash drive is connected, the
following screen will be displayed:
Press the
[1]
key (INTERNAL DIRECTORY). The following screen will be
displayed:
1. INTERNAL DIRECTORY
2. THUMB DRIVE DIR
PRINT DIRECTORY
1.
FULL DIRECTORY
2.
SHORT DIRECTORY
1.
RECORD ID
2.
PRINT RECORD
3.
RECORD DIRECTORY
4.
SAVE/RES RECORD
5.
ERASE RECORD
6. NEXT PAGE
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC