Vanguard EZCT-S2A User Manual
Page 41
REV 1 EZCT S2A USER’S MANUAL
37
3.3.5. Erasing Test Records From the Flash EEPROM
You can erase individual or all test records stored in the EZCT S2A’s Flash EEPROM. To erase a
test record:
a. Start from the “START-UP” menu:
Press the
[2]
key (SETUP).
b. The following screen will be displayed:
Press the
[5]
key (ERASE RECORD).
c. The following screen will be displayed:
NOTE
The above screen will be displayed only if a USB Flash drive is NOT connected
to the EZCT S2A’s USB Flash drive port. If a USB Flash drive is connected, the
following screen will be displayed:
Press the
[1]
key (ERASE INTERNAL REC). The following screen will be
displayed:
1. ERASE INTERNAL REC
2. ERASE THUMB DRV REC
ERASE RECORD
1.
ERASE SINGLE REC.
2.
ERASE ALL RECORDS
1.
RECORD ID
2.
PRINT RECORD
3.
RECORD DIRECTORY
4.
SAVE/RES RECORD
5.
ERASE RECORD
6. NEXT PAGE
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC