Vanguard EZCT-S2A User Manual
Page 49
REV 1 EZCT S2A USER’S MANUAL
45
3.4.2. Printing a Directory of Test Plans Stored in the EZCT S2A’s Memory
You can print a directory of all the test plans stored in the EZCT S2A’s Flash EEPROM using the
steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the
[3]
key (PLAN DIRECTORY).
c. The following screen will be displayed while the test plan directory is printed on the
thermal printer:
NOTE
The above screen will be displayed only if a USB Flash drive is NOT connected
to the EZCT S2A’s USB Flash drive port. If a USB Flash drive is connected, the
following screen will be displayed:
Press the
[1]
key (INTERNAL DIRECTORY). Continue with the steps below:
1. INTERNAL DIRECTORY
2. THUMB DRIVE DIR
PRINTING DIRECTORY
1.
load test plan
2.
unload test plan
3.
plan directory
4.
extract test plan
5.
print test plan
6.
erase test plan
7.
copy to thumb drive
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC