Vanguard EZCT-S2A User Manual
Page 55
REV 1 EZCT S2A USER’S MANUAL
51
3.4.5. Erasing Test Plans From the Flash EEPROM
To erase one or all test plans from the EZCT S2A’s Flash EEPROM:
a. Start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the
[6]
key (ERASE TEST PLAN).
c. The following screen will be displayed:
NOTE
The above screen will be displayed only if a USB Flash drive is NOT connected
to the EZCT S2A’s USB Flash drive port. If a USB Flash drive is connected, the
following screen will be displayed:
Press the
[1]
key (ERASE INTERNAL PLAN). The following screen will be
displayed:
1. Erase internal plan
2. erase thmb drv plan
ERASE TEST PLAN
1. ERASE SINGLE PLAN
2. ERASE ALL PLANS
1.
load test plan
2.
unload test plan
3.
plan directory
4.
extract test plan
5.
print test plan
6.
erase test plan
7.
copy to thumb drive
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC