Vanguard EZCT-S2A User Manual
Page 63
REV 1 EZCT S2A USER’S MANUAL
59
3.4.8. Loading a Test Plan from a USB Flash Drive
To load a test plan from a USB Flash drive:
a. Make sure the USB Flash drive is inserted in the EZCT S2A’s USB Flash drive port (“USB
MEM” port). Then start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the
[1]
key (LOAD TEST PLAN).
c. The following screen will be displayed:
Press the
[2]
key (THUMB DRIVE).
d. The following screen will be displayed:
Type the test plan number that you would like to load and press the
[ENTER]
key. If
you do not know the test plan number, you can print a test plan directory using the
instructions in section 3.4.3.
LOAD TEST PLAN
NUMBER:
1. INTERNAL STORAGE
2. THUMB DRIVE
1.
load test plan
2.
unload test plan
3.
plan directory
4.
extract test plan
5.
print test plan
6.
erase test plan
7.
copy to thumb drive
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC