Vanguard EZCT-S2A User Manual
Page 65
REV 1 EZCT S2A USER’S MANUAL
61
3.4.9. Running a Test Using a Loaded Test Plan
Once a test plan has been loaded into the working memory (see sections 3.4.7 and 3.4.8 for
directions), it can be used to run a test. To run a test using a loaded test plan:
a. Make sure a test plan has been loaded into the working memory and then start from the
“START-UP” menu:
Press the
[1]
key (RUN TEST).
b. The following screen will be displayed (this screen will only be displayed if a test plan
has been loaded first):
1. RUN WITH PROMPTS
Press the
[1]
key to run the test with prompts. Continue to step c.
2. RUN AUTONOMOUSLY
Press the
[2]
key to run the test autonomously. The following screen will be
displayed:
Press the
[START]
key. The following screen will be displayed:
CABLES WILL BE
ENERGIZED!
"START" TO BEGIN
TEST PLAN LOADED
1.
RUN WITH PROMPTS
2.
RUN AUTONOMOUSLY
3.
UNLOAD TEST PLAN
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC